新闻资讯

南方双彩网>>新闻资讯 >

邮箱和倡议机冷却体系的洗濯要领!

日期:2020-01-02   源头:http://www.degradedijital.com/
  燃料不绝是困扰工程呆板用户的标题之一。除了种种过滤步伐外,还需要活期整理油箱,以减轻过滤体系的包袱。这里,为大家分享一下油箱洗濯的要领,除了洗濯外,倡议机冷却体系也需要洗濯,这里也先容一下。
  Fuel is one of the problems that perplex the users of construction machinery. In addition to various filtering measures, the oil tank needs to be cleaned regularly to reduce the burden of the filtering system. Here, I'd like to share with you the cleaning methods of the oil tank. In addition to cleaning, the engine cooling system also needs to be cleaned, which is also introduced here.
  更约莫的是吹气法,预备小空压机即可。洗濯时释放燃油,但要警戒不要用完燃油。将紧缩气氛颠末塑料管运送到油箱底部,使柴油重复翻腾洗濯,革新气管的位置和方向,洗濯整个油箱。洗濯后立刻清空油箱,使油中悬浮的杂质随柴油一同流出。要是流出的柴油不洁净,也需要用上述要领再次洗濯,直到流出的油不含杂质。
  The simplest way is to blow air. Prepare a small air compressor. Release fuel during cleaning, but be careful not to run out of fuel. The compressed air is delivered to the bottom of the oil tank through the plastic pipe, so that the diesel oil can be repeatedly rinsed, the position and direction of the gas pipe can be changed, and the whole oil tank can be rinsed. Empty the oil tank immediately after cleaning, so that the suspended impurities in the oil flow out with the diesel oil. If the diesel oil is not clean, it also needs to be cleaned again with the above method until the oil does not contain impurities.
  蒸汽法结果很好,但只需在条件允许的环境下。要是你能用蒸汽的话,就尝尝吧。洗濯时,需要将全部的柴油,取出油箱,然后将油箱灌满一半以上的水,将蒸汽从油箱的出水口注入水中,使油箱的水沸腾,约莫一个小时。此时,粘在盒壁上的胶水和种种杂质已被水溶解或从盒壁上疏散出来。水箱可延续彻底冲洗两次。
  The steam method works well, but only when conditions permit. If you can use steam, try it. When cleaning, it is necessary to take out all diesel oil from the tank, fill the tank with more than half of the water, and inject steam from the outlet of the tank into the water, so that the water in the tank boils for about an hour. At this time, the glue and various impurities on the box wall have been dissolved by water or separated from the box wall. The water tank can be thoroughly rinsed twice in a row.
  另一种常用的要领是溶剂法,它运用一种叫做氢氧化钠的化学物质(通常称为烧碱或氢氧化钠)。起首用热水洗濯水箱,然后用紧缩气氛吹干,然后将含有10%氢氧化钠的水溶液浸入水箱,用净水冲洗水箱。
  Another common method is the solvent method, which uses a chemical called sodium hydroxide (usually called caustic soda or sodium hydroxide). First, clean the water tank with hot water, then dry it with compressed air, then immerse the aqueous solution containing 10% sodium hydroxide into the water tank, and wash the water tank with clean water.
加长臂挖掘机出租
  倡议机冷却体系的撤除也需要预备氢氧化钠。倡议机封锁后,等候温度下降,把冷却液,15%的氢氧化钠溶液,等8到12小时启动引擎,比及温度上升到80 ~ 90度抑制,立刻释放洗濯液,防范沉淀。然后用净水洗净。
  The removal of the engine cooling system also requires the preparation of sodium hydroxide. After the engine is shut down, wait for the temperature to drop, turn on the coolant, 15% sodium hydroxide solution, wait for 8 to 12 hours to start the engine, wait until the temperature rises to 80 to 90 degrees to stop, immediately release the cleaning fluid to prevent precipitation. Then wash with water.
  一些铝合金气缸盖,此时可以依据硅酸钠(俗称泡碱)50克,液体胰子20克,水10公斤的比例制备洁净液,冷却体系,运转一个小时左右,洁净液,然后用净水洗净。
  Some aluminum alloy cylinder heads, at this time, can be prepared according to the proportion of 50g sodium silicate (commonly known as sodium silicate), 20g liquid soap, and 10kg water. The cooling system runs for about an hour. The cleaning solution is then washed with clear water.
  本文由http://www.degradedijital.com/公布
  This article is published by http://www.dyqing.com/

【本站图片均由网站全部方提供,局部图片源头于网络,如偶然偶然中陵犯了某媒体或集团私家的知识产权,请来信或来电告之,本网站将立刻删除。】