新闻资讯

南方双彩网>>新闻资讯 >

加长臂挖掘机常出现的拦阻有哪些?

日期:2019-02-12   源头:http://www.degradedijital.com/
  挖掘机的加长臂改装可以资助原本的呆板有越发单薄的动力,长臂挖掘机在施工园地愈加独领风骚,挖掘机加长臂的需求也水涨船高。南方双彩网公司通常接到很多挖掘机老板来电咨询关于针对挖掘机改装加长臂后出现的种种拦阻的标题,现把几个普遍的标题与大家分享。
  The modification of the excavator's elongated arm can help the original machinery to have more powerful power. The long arm excavator is more and more dominant in the construction site, and the demand for the excavator's elongated arm is also rising. Our company often receives many calls from excavator owners to consult about the problems of various kinds of faults after the excavator has been refitted and lengthened. Now we share some common problems with you.
  种种拦阻阐发:
  Fault analysis of various types:
  1、挖机右行走和铲斗无方法,动臂和斗杆方法慢
  1. The digger moves right and the bucket does not move, the moving arm and the bucket pole move slowly.
  在互换完控制阀总成的密封后即出现此拦阻。测后泵收铲斗时的压力为1.5Mpa,远小于正常值的28.5Mpa。在预备互换两路的安全阀时,发现拦阻一侧的安全阀位置上为一堵头而原堵头的位置却陈设了安全阀。互换准确位置后呆板正常。原来维修职员互换完控制阀总成的密封后,将该组阀的安全阀与堵头位置装反。
  This failure occurs after replacing the seal of the control valve assembly. After measurement, the pressure of the pump bucket is 1.5 Mpa, which is much lower than the normal value of 28.5 Mpa. When preparing to exchange two safety valves, it is found that the position of the safety valve on the fault side is a plug while the position of the original plug is installed with a safety valve. The machine is normal after the correct position is exchanged. After replacing the seal of the control valve assembly, the original maintenance personnel installed the safety valve and the plug position of the group of valves in reverse.
  2、改装成挖掘机加长臂后,全车慢、有力
  2. After refitting the excavator to lengthen the arm, the whole vehicle is slow and weak.
  机主应声刚互换了先导泵油封,但互换后变乱了十几分钟不绝很正常,然后突然就不可了。依据此环境,起首怀疑先导压力不敷。
  The pilot pump oil seal has just been replaced, but it has been working normally for ten minutes after the replacement, and then suddenly no longer works. According to this situation, we first suspect that the pilot pressure is insufficient.
  经测试先导压力极低,决议剖析先导泵。
  After testing, the pilot pressure is very low, so it is decided to decompose the pilot pump.
  发现先导泵输入轴的骨架油封已挤出,此缘故缘故原因有两种:一是陈设标题,二是该处压力过高。延续剖析发现先导泵的油封方向装反。此处才是拦阻的真正缘故缘故原因,当刚末端变乱时,骨架油封没有完全粉碎,仍可正常变乱,因骨架油封只能遭受高压,故油封很快粉碎,招致先导压力油从损弊端泄出。
加长臂挖掘机出租
  First, it is found that the skeleton oil seal of the input shaft of the pilot pump has been extruded. There are two reasons for this: one is the installation problem, the other is the excessive pressure at this point. Further decomposition found that the oil seal direction of the pilot pump is reversed. This is the real reason for the failure. When the skeleton oil seal is first working, it is not completely damaged and can still work normally. Because the skeleton oil seal can only withstand low pressure, the oil seal is quickly damaged, resulting in the leakage of the pilot pressure oil from the damaged place.
  3、改装成挖掘机加长臂后,倡议机起动后斗杆油缸的活塞杆自动缩回,别的方法正常。
  3. The piston rod of the bucket rod cylinder automatically retracts after the engine starts when the excavator is refitted to lengthen the arm, and other actions are normal.
  经查抄,一别的方法正常;二提起动臂后斗杆下沉较快。互换斗杆先导管后拦阻依旧,说明拦阻在控制阀或斗杆油缸,本着先易后难的准绳。拆检控制阀杆,发现阀杆卡在活塞杆缩回位置,用橡胶螂头和铜棒震荡后取出阀杆。可见有闪亮铁末,讨论斗杆下沉较快。坚强拦阻源头为加长臂斗杆缸筒拉伤,拆检斗杆油缸后证明。
  After checking, one of the others acted normally, and the bucket rod sinks faster after lifting the starting arm. Exchange bucket rod catheter failure is still the same, indicating that the failure in the control valve or bucket rod cylinder, in line with the principle of easy before difficult. The control valve stem is disassembled and checked. It is found that the valve stem is stuck in the retracted position of the piston rod. The valve stem is removed after vibration with rubber Hydra head and copper rod. It can be seen that there are shining iron poles, the connection bucket rod sinks faster. Judging that the fault originated from the pull of the cylinder of the extended arm bucket rod, it was confirmed after disassembling and inspecting the cylinder of the bucket rod.
  今天的内容就先为大家先容到这里了,要是您在运用挖掘机加长臂时另有别的疑问,欢迎您点击南方双彩网的官网举行咨询:http://www.degradedijital.com/
  Today's content is introduced here. If you have any questions when using the excavator to lengthen the arm, you are welcome to click on our official website for consultation: http://www.degradedijital.com./

【本站图片均由网站全部方提供,局部图片源头于网络,如偶然偶然中陵犯了某媒体或集团私家的知识产权,请来信或来电告之,本网站将立刻删除。】